Pioneer DVR-660H-S - Manual (Page 51)

Playback
51
En
06
Playing Audio CDs and WMA/MP3
discs
The table below shows the basic playback
controls for Audio CDs
1
, and WMA/MP3 files.
Playing Video CDs/Super VCDs
The table below shows the basic playback
controls for Video CDs/Super VCDs.
Some discs feature Playback Control (PBC
for short) menus. These discs show PBC in
the display when you load them and display
a menu on-screen from where you can select
what to watch.
2
During playback, enter a title
number then press ENTER to
skip directly to that title.
Press CLEAR to clear a number
entry and start again.
(Commercial back/skip) Each
press skips backward/forward
progressively up to a maximum
of two hours in either direction.
While paused, press and hold
to start slow-motion playback.
Press repeatedly to change the
playback speed.
While paused, press to advance
a single frame in either
direction.
Press to start playback.
Press to stop playback.
Pauses playback, or restarts
playback when paused.
Press to start scanning. Press
again to increase the scanning
speed. (There are two scan
speeds; the current scan speed
is shown on-screen.)
Press to skip to previous/next
track.
Note
1 If you want to play a DTS Audio CD, make sure the recorder is connected to a DTS-compatible amp/receiver with
a digital connection. Noise will be output through the analog outputs. Also make sure that STEREO is selected
using the
AUDIO button (see Switching audio channels on page 58).
ENTER
CM SKIP CM BACK
PLAY
STOP
PAUSE
PREV NEXT
Press to start playback.
Video CD only: If
RESUME is
displayed on-screen, playback
starts from the place last
stopped.
Press to stop playback.
Video CD only: You can resume
playback from the same point
by pressing
 PLAY. (Press
 STOP again to cancel the
resume function.)
Pauses playback, or restarts
playback when paused.
Press to start scanning. Press
repeatedly to increase the
scanning speed.
Press to skip to previous/next
track.
When a PBC menu is displayed,
press to display the previous/
next page. (During playback
you can also use the front panel
CH +/– buttons.)
During playback, enter a track
number then press ENTER to
skip directly to that track.
Press CLEAR to clear a number
entry and start again.
While a PBC menu screen is
displayed, use to select
numbered menu items.
2 When playing in PBC mode, some playback features, such as search, repeat and programme play are not
available. You can play a PBC Video CD/Super VCD in non-PBC mode by starting playback using the Disc
Navigator (see Using the Disc Navigator with playback-only discs on page 54).
PLAY
STOP
PAUSE
PREV NEXT
ENTER
DVR660HS_TLT_EN.book 51 ページ ２００８年２月２０日 水曜日 午前１１時３３分