Paradyne 8310 MVLt - Manual (Page 32)

Configuring the Hotwire DSLAM
3-2 8000-A2-GB26-10 January 1999
Configuring the DSL Cards
Use the procedures in the following order to minimally configure DSL cards for
user data connectivity. For detailed information on these instructions,
see Chapter 4,
8310 MVL and 8510 RADSL Card Configuration .
For information about MCC and DSL card network topologies, consult the Hotwire
DSLAM for 8310 MVL and 8510 RADSL Cards Network Configuration Guide. To
configure the MCC card, refer to the
Hotwire Management Communications
Controller (MCC) Card, IP Conservative, User’s Guide.
The following table lists optional steps to configure the VNID for the DSL card.
For each DSL card, to . . . See . . .
1. Configure VNID(s) on a RADSL or MVL
card
Configuring VNID(s) on a DSL Card ,
page 3-3.
2. Select the active VNID on each RADSL
or MVL port
Configuring the Active VNID on each DSL
Port
, page 3-4.
3. Configure static users Configuring Static Users , page 3-5.
4. Configure IP filter rules Configuring IP Filter Rules , page 3-7.