Paradyne 8310 MVLt - Manual (Page 33)

Configuring the Hotwire DSLAM
3-3 8000-A2-GB26-10 January 1999
Configuring VNID(s) on a DSL Card
"
Procedure
To configure at least one VNID for this RADSL or MVL card from the Hotwire –
DSL Card menu:
1. Follow this menu selection sequence :
Configuration
→
Bridge
→
Card VNID (A-E-B)
2. Type 0 or press Enter at the Item Number (0 to add new record):
prompt.
3. Enter the VNID at the Enter VNID ID between 2 and 4094 or
space to delete: prompt.
4. Enter enabled at the Enabled/Disabled: prompt in the Mux Fwd field.
(Default = enabled.)
5. Enter disabled at the Enabled/Disabled: prompt in the IP Filter field.
(Default = disabled.)
6. Enter enabled at the Enabled/Disabled: prompt in the IP Scoping field.
(Default = enabled.)
7. If desired, enter an ISP domain name at the Domain Name: prompt.
Example: If entering a VNID for XYZ Company, enter XYZ as the Domain
Name.
8. Enter yes at the yes/no: prompt to save your changes.
NOTES:
For more information about the fields listed above, see Table 4-4 , Bridge
Options, in Chapter 4, 8310 MVL and 8510 RADSL Card Configuration.
Also, refer to Service Domain in the Hotwire DSLAM for 8310 MVL and
8510 RADSL Cards Network Configuration Guide.