Paradyne 8310 MVLt - Manual (Page 40)

8310 MVL and 8510 RADSL Card Configuration
4-2 8000-A2-GB26-10 January 1999
NOTE:
Only a user who logs in to the Hotwire DSLAM with Administrative permission
can configure the DSL card.
"
Procedure
To configure card information, time/date, clear NVRAM, upload or download
configuration sets, download new firmware, or reset card:
1. Follow this menu selection sequence:
Configuration
→
Card Status (A-A)
2. The Card Status menu appears. Enter the desired value on each selected
screen and field as shown in Table 4-1 and press Enter.
Table 4-1. Card Status Options (1 of 3)
Card Info (Card Information) A-A-A
Gives the user the ability to configure basic card-level information.
Card Name – 16 alphanumeric characters. Name assigned to the card.
Card Contact – 32 alphanumeric characters. Name or number of party responsible for
card.
Card Location – 16 alphanumeric characters. Location assigned to the card.
Local Control Terminal Port Mode – Standard/Extended (Default = Standard).
Standard is for USA keyboards; Extended is for European keyboards.
Remote Control Terminal Port Mode – Standard/Extended (Default = Standard).
Standard is for USA keyboards; Extended is for European keyboards.
Time/Date A-A-B
Gives the user the ability to view the time zone, local time, and date on the DSL card.
Time zone – Name of your time zone.
Local Time/Date – Time in hh.mm format (am or pm). Date in mm/dd/yy format.
NOTE: At system boot time, the time zone, local time, and date on the DSL cards
automatically synchronizes with the MCC card.
NVRAM Clear A-A-C
Gives the user the ability to clear out the Non-Volatile RAM (NVRAM) in order to reuse
the card or to reconfigure the current card.
CAUTION: If you select yes on this screen, you will permanently remove all of the
configuration information you have stored on this card. The system will
perform a reset and return to the factory configuration.