Paradyne 8310 MVLt - Manual (Page 53)

8310 MVL and 8510 RADSL Card Configuration
4-15 8000-A2-GB26-10 January 1999
Table 4-5. Service Node Options
SN Configuration A-F
Displays endpoint information for the 5620 RTU or 6310 MVL modem.
Port # – Enter the RADSL or MVL port number (1–4).
SN Type – Model number of SN connected to the DSL port. For Model 8510 RADSL,
the SN is 5620. For Model 8310 MVL, the SN is 6310. (This field is read-only.)
System Name – 16 alphanumeric characters. Enter the name assigned to the SN.
System Contact – 32 alphanumeric characters. Enter the name or number of the
person responsible for the SN.
System Location – 16 alphanumeric characters. Enter the location of the SN.
Model Num – Model number of card. (This field is read-only.)
Serial Num – Serial number of card. (This field is read-only.)
Firmware Rev – Version of firmware. (This field is read-only.)
Hardware Rev – Version of hardware. (This field is read-only.)
CAP Rev – Version of CAP chipset for Model 8510 RADSL card only. (This field is
read-only.)
MVL Rev – Version of MVL chipset for Model 8310 MVL card only. (This field is
read-only.)
Reset SN? – Yes/No. Enter yes to reset the SN and begin a self-test.
NOTE: Entering yes in the Reset SN field will temporarily disrupt the data path on
the specified DSL port while the SN resets.
SN Selftest Results – Pass/Fail. This field displays the results of the SN self-test, when
completed.