Paradyne 8310 MVLt - Manual (Page 47)

8310 MVL and 8510 RADSL Card Configuration
4-9 8000-A2-GB26-10 January 1999
Table 4-3. Interfaces Options
General (General Interfaces) A-C-A
Gives the user the ability to configure and view basic card interface information about a
given interface, including binding filters.
Interface Name – 3 characters. e1a = Ethernet port; s1c, s1d, s1e and s1f = RADSL or
MVL interface.
Type – Static or Dynamic interface type.
Protocol – HDLC or Ethernet. Interface protocol.
Port List – Ports available on the card.
MTU (max) – 64–1600 bytes (Default = 1536). Receipt of packets above the MTU
setting will be dropped.
NOTE: The above MTU values are the only values you may enter. Make certain
that if you change from the default value, the new numbers are appropriate
to your network. Do a card reset or reset the Ethernet interface.
Inbound Filter Name – Enter the filter name with a maximum of 12 characters. This
field appears only if the DSL interface selected is s1c–s1f. To view a list of configured
inbound filters, press Ctrl-v.
NOTE: An inbound filter acts on packets in the upstream direction from the client to
the NSP server.
Outbound Filter Name – Enter the filter name with a maximum of 12 characters. This
field appears only if the DSL interface selected is s1c–s1f. To view a list of configured
outbound filters, press Ctrl-v.
NOTE: An outbound filter acts on packets in the downstream direction from the
NSP server to the client.
Control (Control Interfaces) A-C-B
Gives the user the ability to start, stop, and monitor (up, down, or testing) the current
state of an interface.
NOTE: Stopping the interface disables all of the traffic on that port, including
diagnostics. If you want to disable only customer traffic, disable all VNIDs
on that port.
There are no user-configurable elements on this screen except for the ability to start
and stop the interface. Valid choices for the DSL card are e1a, s1c, s1d, s1e, and s1f.