Phase One H 5 - Manual (Page 10)

Using the Phase One H 5
Phase One has made using the Phase One H 5 as close to using film
as digital photography can be. The first step to using the Phase One H 5
is to start the application. Double-click the folder called “Capture One
Application” on the hard drive and then double-click the “Capture One”
icon. This will start the program that controls the camera back. After a
few seconds the software will make a small “click” sound and the camera
will beep. These two sounds indicate that everything is ready.
In practice the Phase One H 5 can now take pictures. However before
shooting it is a good idea to ensure that the software settings are optimal.
This will ensure the best possible image quality and workflow.
5) Follow the on-screen prompts. When the installation is completed,
restart the computer.
Installed Items
The installer creates a folder on your hard disk called “Capture One.”
This folder contains the application as well as several sub-folders.
They are:
Captures
As photographs are taken with the Phase One H 5, this is the default
location where raw capture files are stored. Also, you may organize
your raw capture files by creating new folder on the harddrive.
Previews
The software application automatically creates a low resolution
(approximately 1MB) preview image to use for color and tonal
adjustments. All preview files are stored in the “Previews” folder. If any
files are deleted from here the program will automatically generate new
previews the next time the Capture One software is started.
Images
By default developed images will be placed in this folder. Again, the
preferences can be used to change where developed files will be placed.
Goodies
The “Goodies” folder holds aliases to files on the install disk as well as
other related files.
2.2
Install the Software Install the Software
2.3