Phase One H 5 - Manual (Page 34)

Photographic Equipment Set-up
In addition to setting up the computer, the camera must be prepared
to work with the Phase One H 5.
This involves a few simple steps:
1) A Ground Glass Mask is included.
This must be installed in the viewfinder to
ensure correct framing. Remove the camera
viewfinder and focusing screen (refer to
the camera users manual for detailed
instructions). Insert the Ground Glass Mask
and replace the viewing screen and the
viewfinder.
2) If a Mamiya RZ67 Pro II is used, connect
the mounting plate to the camera and then
connect the cable from the mounting plate to
the connector on the front of the Mamiya.
Be sure that the cable is connected and
locked properly; the latching mechanism will
be on the bottom.
3) Connect the camera back to the camera or mounting plate.
Be sure that the camera back is firmlyconnected to the camera before
releasing! The small screw on the top of the camera back can be
tightened with the supplied screwdriver to prevent it from being
accidentally removed.
Install the PCI IEEE 1394 card (if required).
While the owner’s manual for the particular computer should be
consulted, the basic steps to installing the card are as follows:
1) Shut down and unplug the computer.
2) Remove the cover, exposing the motherboard.
3) Choose an empty PCI slot and remove the screw and cover.
4) Gently place the card into the slot with the 1394 connectors facing
through the opening.
5) Press straight down and slightly rock the card until it is firmly seated
in the slot.
6) Replace the screw to hold the card in place.
7) Replace the case, restart the computer.
8) On a Windows computer after restarting, a dialog box appears
indicating that Windows found new hardware (the IEEE 1394 card).
There may be a prompted for the Windows 98/2000 CD if Windows
cannot find the driver.
10.2
Windows Getting Started
10.3
Windows Getting Started