Ups to dvr communication and power connections, 95 ups to dx8100 connections – Pelco DX8100 User Manual
Page 71
C2629M-A (6/07)
71
Appendix D: Connecting an Uninterruptible Power Supply (UPS)
If uninterrupted operation is desired and the power grid cannot provide adequate uptime, it is highly recommended that each DX8100 Series DVR
be connected to a UPS device (not supplied). A UPS device will supply a limited amount of battery backup power in the event of a power failure.
Each UPS device should be configured to shut down its corresponding DVR safely during an extended period on battery power.
Only those UPS devices that exhibit the Designed for Microsoft Windows XP logo and are listed on the Windows 2000 Hardware Compatibility
List are approved for use with the DX8100 Series DVR.
WARNING: Do not install on the DX8100 any power management software that may come with your UPS device. The DX8100’s operating
system includes built-in services designed to communicate with UPS devices that exhibit the Designed for Microsoft Windows XP logo.
The following instructions are meant as a general guide for connecting a UPS device to the DX8100 Series DVR. The example below illustrates
the installation of an American Power Conversion UPS. This guide is not intended as a representation of how to install every possible make and
model of UPS device. Follow the directions that came with your UPS device to ensure that the installation process is completed properly.
UPS TO DVR COMMUNICATION AND POWER CONNECTIONS
1. Shut down the DX8100. Refer to Shutting Down for instructions.
2. Connect the UPS to the DX8100 using a standard USB cable.
3. Connect the other end of the USB cable to one of the four USB 2.0 ports on the back panel of the DVR.
4. Connect the power cord of the UPS to a standard wall socket.
5. Connect the power cord of the DX8100 to one of the power outlets on the UPS.
6. Turn the UPS device power switch on.
7. Turn the DX8100 power switch on.
IN1
IN2
IN3
IN4
IN5
IN6
IN7
IN8
IN9
IN10
IN11
IN12
IN13
IN14
IN15
IN16
OUT16
OUT15
OUT14
OUT13
OUT12
OUT11
OUT10
OUT9
OUT8
OUT7
OUT6
OUT5
OUT4
OUT3
OUT2
OUT1
ALARM INPUTS
RELAY OUTPUTS
1 2 2 4 5 6 7 8 GND
9 10 11 12 13 14 15 16
1 2 2 4 5 6 7 8 GND
9 10 11 12 13 14 15 16
POWER
CONNECTION
POWER
CONNECTION
UPS
RS-232
USB CABLE
Figure 94. UPS to DX8100 Connections