Pelco DX8100 - Manual (Page 83)

C2629M-A (6/07) 83
The table below describes the PV140 RS-232 to RS-422 converter.
Table M. VSI-PRO DB9-to-DB9 Triport Cable
Item Part Description
DB9 (female) PV140 DB9 female connector that interfaces with the triport DB9 male connector. The VSI-PRO triport DB9
male connector pin assignments and the PV140 terminal wiring pin assignments are described below.
Power supply PV140 power transformer provides 12 VDC.
Transmit data PV140 terminal TX+, which connects to the pin 8 (RX+) of the DX8100 RJ-45 connector. For information
about the DX8100 back panel, refer to Figure 11 on page 23.
Transmit data PV140 terminal TX-, which connects to the pin 7 (RX-) of the DX8100 RJ-45 connector. For information about
the DX8100 back panel, refer to Figure 11 on page 23.
RJ-45 User-supplied RJ-45 connector that interfaces the ATM/POS device to DX8100 Port 1–4.
Table N. PV140 DB9 Pinouts
Triport DB9 Male User-Supplied RJ-45 Cable
Pin 2: RD Pin 2: RD
Pin 5: SGND Pin 5: SGND
Connecting ATM/POS Devices via RS-422
To connect ATM/POS devices in a RS-422 configuration:
1. Use the appropriate AVE cable to connect each additional VSI-PRO to an ATM/POS device.
2. Set up one PV140 RS-232 to RS-422 converter and user-supplied RJ-45 cable for each ATM/POS device. For installation instructions, refer
to the PV140 RS-232/422 Converter Kit Installation manual.
ᕢ
ᕦ ᕡ
ᕣ
ᕤ
ᕥ
Figure 107. PV140 and User-Supplied RJ-45 Cable Wiring
3. Insert the RJ-45 plug into Port 1–4 as required.