Panasonic CPC-EX - Manual (Page 26)

Chapter 2. System Overview Section 300-Installation
2-8 DBS Manual - Revised April 2000 DBS-2.3/9.2-300
Printed circuit cards are installed in dedicated slots in the DBS cabinet.
Table 2-3 shows the cards that can be installed in each slot. Figure 2-3 on
page 2-9 illustrates slot labels.
Table 2-3. Printed circuit package slot usage
Card Type Card Acceptable Slots
Analog
Trunks
L-TRK/4
TRK or EC/TRK
L-TRK/8
G-TRK/8
DID/8
Digital Trunks T1/24 EC/TRK
Digital Lines DEC/8 EC 1-8 or EC/TRK
Analog Lines AEC/8 EC 2-8 or EC/TRK
Service
Circuits
SCC-A SCC
SCC-B
Processor Cards CPC-A CPC
CPC-B
CPC-AII
DTMF Circuits MFR/8 AUX1 or AUX2
CPC (See Note 1.)
Interface Cards API (1 or 2 Circuits) AUX1 or AUX2 (See Note 2.)
CBL-M CPC or AUX2 (See Note 3.)
CBL-S
Notes:
1. With one-cabinet systems, the MFR card can be installed in the AUX1 or AUX2 slot,
depending on whether an API card is used. With two-cabinet systems, placement of the MFR
cards differs according to the cable kit used. With Cable Kit Version 1.1, one MFR is installed
in the Master AUX1, and one MFR is installed in the Slave AUX1. With Cable Kit Version
1.2, both MFR cards are installed in the slave cabinet--one in the CPC slot and one in AUX1.
(See page 6-10 for instructions on installing MFR cards in double-cabinet systems.)
2. The API card is installed in AUX1 only when a CBL card is used.
3. Part VB-43110 includes both the CBL-M and CBL-S cards, as well as the required connect-
ing cables. CBL-M is installed in the master cabinet, CBL-S in the slave cabinet.