Figure 4-8 – Panasonic CPC-EX User Manual
Page 72
Chapter 4. Trunks and Lines
Section 300-Installation
4-24
DBS Manual - Revised April 2000
DBS-2.3/9.2-300
4. Set SW1 on the T1 card according to the following table.
These switch settings correspond to the distance between the DBS and the
CSU. To turn a switch on, flip it to the “up” position.
Table 4-18. Switch settings for SW1 on the T1 card
5. Install the T1 card in the “EC/TRK” slot
6. Connect the Sync Cable from CN1 on the Sync Unit to CN5 on the T1
card.
Figure 4-8. Sync Unit and T1 connection, single-cabinet installation
7. Connect the cable attached to CN3 on the T1 MDF card to CN3 on the T1
8. Using an RJ48 cable, connect CN1 on the T1 MDF card to the CSU
(Figure 4-10). The following illustration shows CN1 pinouts.
SW
Distance from the DBS to the CSU
0 to 150 ft.
150-450 ft.
450-655 ft.
SW1
On
Off
Off
SW2
Off
On
Off
SW3
Off
Off
On
SW4
Off
On
Off
SW5
Off
Off
On
SW6
Off
On
Off
SW7
Off
Off
On
SW8
Not used
Not used
Not used
TR K
D EC
D EC
D EC
D EC
D EC
D EC
D EC
D EC
T1
TR K
SCC
CPC
M FR
N
O
T
U
S
E
D
Sync.U nit
C N 5
C N 1
S .U .
Sync Cable