Pioneer DVH-P5650MP - Manual (Page 61)

# If the subwoofer setting has been previously
adjusted, the frequency of that previously se-
lected will be displayed instead of 80.
2 Press m or n to select cut-off fre-
quency.
Each press of m or n selects cut-off fre-
quencies in the following order:
5080125 (Hz)
Only frequencies lower than those in the se-
lected range are outputted from the subwoo-
fer.
3 Press r or q to adjust the output
level of the subwoofer.
Each press of r or q increases or de-
creases the level of the subwoofer. +6  6 is
displayed as the level is increased or
decreased.
Using nonfading output
When the nonfading output setting is on, the
audio signal does not pass through this units
low pass filter (for the subwoofer), but is out-
putted through the RCA output.
1 Press A to select non fading output on/
off setting.
Press A until NOFAD:ON appears in the dis-
play.
# When the subwoofer controller setting is only
P/O :FUL, you can switch to the nonfading out-
put on/off setting. (Refer to page 83.)
2 Press r to turn non fading output on.
NOFAD:ON appears in the display. Nonfading
output is now on.
# To turn non fading output off, press q.
Adjusting nonfading output level
When the nonfading output is on, you can ad-
just the level of nonfading output.
1 Press A to select non fading output set-
ting.
Press A until NOFAD: 0 appears in the dis-
play.
2 Press r or q to adjust the output
level of the non fading.
Each press of r or q increases or de-
creases the level of the non fading. +6  6 is
displayed as the level is increased or
decreased.
Using the high pass filter
When you do not want low sounds from the
subwoofer output frequency range to play
from the front or rear speakers, turn on the
HPF (high pass filter). Only frequencies higher
than those in the selected range are outputted
from the front or rear speakers.
1 Press A to select HPF.
Press A until HPF appears in the display.
2 Press r to turn high pass filter on.
HPF : 80 appears in the display. High pass fil-
ter is now on.
# If the high pass filter has been previously ad-
justed, the frequency of that previously selected
will be displayed instead of HPF : 80.
# To turn high pass filter off, press q.
3 Press m or n to select cut-off fre-
quency.
Each press of m or n selects cut-off fre-
quencies in the following order:
5080125 (Hz)
Audio Adjustments
En
61
Section
11
Audio
Adjustments