Pioneer DVH-P5650MP - Manual (Page 74)

Display Equalizer curve
CUSTOM2 Custom 2
SPR-BASS Super bass
! CUSTOM1 and CUSTOM2 are adjusted
equalizer curves.
! When EQ FLAT is selected no supplement
or correction is made to the sound. This is
useful to check the effect of the equalizer
curves by switching alternatively between
EQ FLAT and a set equalizer curve.
% Press EQ to select the equalizer.
Press EQ repeatedly to switch between the fol-
lowing equalizers:
POWERFULNATURALVOCALEQ FLAT
CUSTOM1CUSTOM2SPR-BASS
Adjusting 3-band parametric
equalizer
For CUSTOM1 and CUSTOM2 equalizer
curves, you can adjust the front, rear and cen-
ter equalizer curves separately by selecting a
center frequency, an equalizer level and a Q
factor for each band.
! A separate CUSTOM1 curve can be cre-
ated for each source.
! A CUSTOM2 curve can be created com-
mon to all sources.
! The center speaker largely determines the
sound image and getting the balance right
isnt easy. We recommend reproducing a 2-
ch. audio (a CD for example) and getting
the balance right among the speakers ex-
cept for the center, and then reproducing a
5.1-ch. audio (Dolby Digital or DTS) and ad-
justing the center speaker output to the
balance you have already got among the
other speakers.
1 Press A and hold until FRONT appears
in the display, then press A to select PEQ.
After FRONT is displayed, press A until PEQ
appears in the display.
# Adjusted PEQ settings are memorized in
CUSTOM1.
2 Press r or q to select the speaker to
be adjusted.
Each press of r or q selects the speaker in
the following order:
FRT (front speakers)CEN (center speaker)
RER (rear speakers)
# You cannot select speakers whose size is set
at OFF.
3 Press n and then press r or q to
select the equalizer band to be adjusted.
Each press of r or q selects equalizer
bands in the following order:
LOW (low)MID (mid)HI (high)
4 Press n and then press r or q to
select the center frequency of selected
band.
Each press of r or q selects the frequency
in the following order:
40Hz50Hz63Hz80Hz100Hz125Hz
160Hz200Hz250Hz315Hz400Hz
500Hz630Hz800Hz1kHz1.2kHz
1.6kHz2kHz2.5kHz3.1kHz4kHz
5kHz6.3kHz8kHz10kHz12kHz
5 Press n and then press r or q to
adjust the equalizer level.
Each press of r or q increases or de-
creases the equalizer level. +6  6 is dis-
played as the level is increased or decreased.
6 Press n and then press r or q to
select the desired Q factor.
Each press r or q switches between the
following Q factor:
WID (wide)NAR (narrow)
Digital Signal Processor
En
74
Section
12