Panasonic KX-FC231NZ - Manual (Page 44)

5. SMS (KX-FC235AL only)
42
L Consult your service provider for more
information.
1 Press {j/OK}.
2 Select “ SMS”, then press {>}.
3 Select “ Public”, then press {>}.
4 Select “ Settings”, then press {>}.
5 Enter “ 0000” (default base unit PIN).
L If you changed the PIN, enter it (page 80).
6 Select “ Message Centre1” or “Message
Centre2”, then press {>}.
7 Edit the number as necessary, then press
{j
/OK}.
8 Select “ Save”, then press {>}.
9 Press {ih}.
Note:
L If your phone is connected to a PBX, you
need to add the PBX line access number and
a dialling pause to the beginning of the
Message Centre 1 phone number.
5.4 Sending a message
5.4.1 Writing and sending a new
message
1 Press {j/OK}.
2 Select “ SMS”, then press {>}.
3 To access the public mailbox
Select “
Public”, then press {>}.
To access a private mailbox
Select the desired mailbox, press {>}, then
enter its password.
4 Select “ Create”, then press {>}.
L If “^ Use Last Text?” is displayed, you
can use the text from the last message
you created by pressing {e}. This
message will be displayed only if the last
message was created using the same
mailbox you selected in step 3.
5 Enter the message (page 46), then press
{j
/OK}.
6 Enter the destination telephone number.
Manually:
Enter the number, up to 20 digits.
Using the handset phonebook:
1. Press {k}.
2. Press {e} or {v} repeatedly to display
the desired item.
L You can also find an item using one of
the search methods on page 32.
3. Press {j/OK}.
Using the Caller ID list:
1. Press {e} or {v} repeatedly to select
the party.
2. Press {j/OK}.
Using the redial list:
1. Press {R} repeatedly to select the
telephone number.
2. Press {j/OK}.
7 If you wish to send the message to the other
party’s mailbox, enter the other party’s
mailbox number after the destination phone
number.
Example: The other party’s phone number
is 123456 and their mailbox number is 1.
Enter 1234561.
L To send the message to the public
mailbox, skip to step 8.
8 Press {j/OK}.
9 To save the message, select “ Yes”, then
press {>}.
L To send the message without saving it,
select “
No”, then press {>}.
10 To send the message, select “ Send”, then
press {>}.
L To cancel sending, press {ih}.
Note:
L This unit supports SMS messages of up to
612 characters, however, the maximum
number of characters you can send or
receive may be limited by your SMS service
provider. Consult your SMS service provider
for details.
L If your message contains over 160
characters, “@@
Long Message@@” is
displayed. Your service provider may treat
{ih}
{j /OK}
{>}{e}{v}
{R}
{ C/T}
{k}
FC235AL-PFQX2248ZA_en.book Page 42 Thursday, May 19, 2005 1:47 PM