Panasonic KX-FC231NZ - Manual (Page 72)

10. Programmable Features
70
“ ON” (default): You will hear the friendly
reception voice guide, pre-recorded messages
and voice time/day stamp.
“
OFF”: Deactivates this feature.
Code #53: Turning SMS ON/OFF (KX-
FC235AL only)
SMS
=OFF [ ±]
See page 41 for details.
Code #54: Changing the recording time for
your TAM/FAX greeting message
GREETING TIME
=16s [ ±]
“ 16s” (default): Maximum recording time is 16
seconds.
“
60s”: Maximum recording time is 60 seconds.
See page 61 for details.
Code #58: Setting the scan contrast
SCAN CONTRAST
=NORMAL [ ±]
To send or copy a document with faint or dark
writing, set this feature before transmission or
copying.
“
NORMAL” (default): Used for normal writing.
“ LIGHT”: Used for dark writing.
“ DARKER”: Used for faint writing.
Code #67: Setting the incoming message
monitor
ICM MONITOR
=ON [ ±]
To hear an incoming message (ICM) from the
speaker when the answering device is recording
the message.
“
ON” (default): You can monitor the incoming
message.
“
OFF”: Deactivates this feature.
Code #68: Setting the Error Correction Mode
(ECM)
ECM SELECTION
=ON [ ±]
This feature is available when the
transmitting/receiving fax machines are ECM
compatible.
“
ON” (default): If there is an error during fax
transmission/reception, the fax machine will
support the communication.
“
OFF”: Deactivates this feature.
Note:
L You cannot change the setting when received
documents are in memory.
Code #76: Setting the connecting tone
CONNECTING TONE
=ON [ ±]
If you often have trouble when sending faxes,
this feature allows you to hear connecting tones:
fax tone, ring back tone and busy tone. You can
use these tones to confirm the status of the other
party’s machine.
“
ON” (default): You will hear connecting tones.
“ OFF”: Deactivates this feature.
Note:
L If the ring back tone continues, the other
party’s machine may not be a fax machine or
may have run out of paper. Check with the
other party.
L The connecting tone volume cannot be
adjusted.
Code #77: Changing the receiving mode in
the auto answer setting
AUTO ANSWER
=TAM/FAX [ ±]
“ TAM/FAX” (default): Telephone Answering
Machine/Fax mode (page 55)
“
FAX ONLY”: Fax only mode (page 56)
Code #80: Resetting advanced features to
their default settings
SET DEFAULT
RESET=NO [ ±]
To reset the advanced features:
1. Press {MENU}.
2. Press {#}, then {8}{0}.
3. Press {A} or {B} repeatedly to select “ YES”.
4. Press {SET}.
5. Press {SET} again.
6. Press {MENU}.
Note:
L The ECM selection (feature #68 on page 70)
will not be reset.
FC235AL-PFQX2248ZA_en.book Page 70 Thursday, May 19, 2005 1:47 PM