Panasonic KX-FC231NZ - Manual (Page 81)

10. Programmable Features
79
Storing/changing emergency numbers
These settings determine which telephone
numbers can be dialled while the call bar feature
is ON (page 77).
1. Press {j/OK}.
2. Select “ Base Unit Setup”, then press
{>} .
3. Enter “ 0000” (default base unit PIN).
L If you changed the PIN, enter it (page 80).
4. Select “ Call Options”, then press {>}.
5. Select “ Emergency No.”, then press {>}.
6. Select a memory location, then press {>}.
L If the memory location already contains
an emergency number, the number is
displayed.
7. Enter/edit the number, then press {j/OK}.
L To erase an emergency number, press
and hold {C/T}.
8. Press {ih}.
Note:
L The default setting for emergency numbers
are stored in the first 3 memory locations. It is
recommended that you do not overwrite
these numbers.
Selecting area codes to be deleted
automatically
In some situations, phone numbers stored
automatically in the Caller ID list (page 36) will
include area codes. If you do not want to dial the
area codes when making calls from the Caller ID
list, you can store the area codes which you want
the unit to delete automatically.
Example: You have stored the area code “
123”.
If you make a call from the Caller ID list to the
phone number “
123-456-7890”, the unit dials
“ 456-7890”.
1. Press {j/OK}.
2. Select “ Base Unit Setup”, then press
{>} .
3. Enter “ 0000” (default base unit PIN).
L If you changed the PIN, enter it (page 80).
4. Select “ Call Options”, then press {>}.
5. Select “ ARS Settings”, then press {>}.
6. Select “ Area Code”, then press {>}.
7. Select an area code location (1-4), then
press {>}.
L If the location already contains an area
code, the code is displayed.
8. Enter an area code (5 digits max.), then
press {j/OK}.
9. Press {ih}.
Note:
L The use of this feature can prevent a National
Call from being dialled. E.g., in the case of
the South Island, the “03” will be omitted and
will therefore prevent a National Call to other
areas of the South Island. (for New Zealand
users only)
Setting call restriction
You can restrict selected handsets from dialling
certain numbers. You can assign up to 6 phone
numbers to be restricted, and select which
handsets will be restricted. Storing area codes
here will prevent the restricted handsets from
dialling any phone number in that area code. If a
restricted number is dialled, the call will not be
connected and the restricted number will flash
on the display.
1. Press {j/OK}.
2. Select “ Base Unit Setup”, then press
{>} .
3. Enter “ 0000” (default base unit PIN).
L If you changed the PIN, enter it (page 80).
4. Select “ Call Options”, then press {>}.
5. Select “ Call Restrict”, then press {>}.
6. Set which handsets will be restricted by
pressing the desired handset number.
L All the registered handset numbers will be
displayed.
L Flashing numbers indicate call restriction
is turned ON for the corresponding
handset.
L To turn call restriction OFF for a handset,
press the number again. The number will
stop flashing.
7. Press {j/OK}.
8. Select a memory location, then press {>}.
L If the memory location already contains a
restricted number, the number is
displayed.
9. Enter the phone number or area code to be
restricted (up to 8 digits), then press
{j
/OK}.
L To erase a restricted number, press
{
C/T}.
10. Press {ih}.
FC235AL-PFQX2248ZA_en.book Page 79 Thursday, May 19, 2005 1:47 PM