Panasonic KX-FC231NZ - Manual (Page 94)

13. Help
92
13.3.4 Fax – sending
The handset stops
working while being used. L Disconnect the power cord and turn OFF the handset to reset the
unit. Connect the power cord, turn ON the handset and try again.
While storing an item in
the phonebook or
assigning a one touch
dial, the handset starts to
ring. L To answer a call, press {C} or {s}. Storing will be cancelled.
Store the name and number again.
I assigned a phonebook
item to a desired category,
but category ring tones
will not sound. L You must subscribe to Caller ID service.
L Set to TEL mode, TAM/FAX mode or FAX ONLY mode to use SMS
features.
I cannot redial by
pressing {R}. L If the redialled number was more than 24 digits long, the number
will not be redialled. Redial the number manually.
7 flashes or the
handset beeps
intermittently while it is in
use.
L Fully charge the batteries (page 22).
I fully charged the
batteries, but 7 still
flashes. L Clean the charge contacts and charge again (page 22).
L It is time to replace the batteries (page 20).
I cannot receive
documents using the
handset. L The memory is full of received documents due to a lack of
recording paper or a recording paper jam. Install paper (page 19)
or clear the jammed paper (page 97).
I cannot make a call with
the handset. L The call bar feature is set. Turn it OFF (page 77).
L You dialled a call restricted number. Remove the number from the
call restricted list (page 79).
L The key lock feature is turned ON. Turn it OFF (page 30).
I cannot register a
handset to a base unit. L The maximum number of base units are already registered to the
handset. Cancel unused base unit registrations from the handset
(page 82).
L The maximum number of handsets are already registered to the
base unit. Cancel unused handset registrations from the base unit
(page 82).
L You entered the wrong PIN. If you forget your PIN, consult your
nearest Panasonic service centre.
L Locate the handset and the base unit away from other electrical
appliances.
Problem Cause & Solution
I cannot send documents. L The other party’s fax machine is busy or has run out of recording
paper. Try again.
L The other party does not have a fax machine. Check with the other
party.
L The other party’s fax machine failed to answer the fax
automatically. Send the fax manually (page 48).
L The memory is full of received documents and the quick scan
(feature #34 on page 68) is ON. Turn this feature OFF, and send
the fax again.
Problem Cause & Solution
FC235AL-PFQX2248ZA_en.book Page 92 Thursday, May 19, 2005 1:47 PM