4 main menu – Planet Technology WGS3-404 User Manual
Page 148
WGS3 Layer 3 Switch User’s Manual
- 140 -
5.4 Main Menu
Using the on-board Web agent, you can define system parameters, manage and control the switch, and
all its ports, or monitor network conditions. The interface screen includes the menu tree on the left side
and a list of commands beneath the image of the switch. The following table briefly describes the
selections available from this program.
Menu Description
System Information Menu
System Information
Provides basic system description, including contact information.
Switch Information
Shows hardware/firmware version numbers, power status, and expansion
modules used in the switch.
Management Setup Menu
Network Configuration
*1
Includes IP Configuration, Ping facility, and HTTP (Web agent) setup.
Serial Port
Configuration
Sets communication parameters for the serial port, including baud rate, console
time-out, and screen data refresh interval.
SNMP Configuration
Activates authentication failure traps; and configures community access strings,
and trap managers.
User Configuration
Sets the user names and passwords for system access.
TFTP Download
Downloads new version of firmware to update your system (in-band).
Configuration File
Save or restores configuration data based on the specified file.
Device Control Menu
System Mode
*3
Sets the switch to operate as a Layer 2 switch or as a multilayer routing switch.
Layer 2 Menu
Configures port communication mode, mirror ports, port trunking and static
unicast/multicast address.
Bridge Menu
Configures GMRP and GVRP for the bridge, and STA for the global bridge or for
specific ports.
VLAN Menu
Configures VLAN settings for specific ports, and defines the port membership for
VLAN groups.
IGMP Snooping
Configuration
*1
Configures IGMP multicast filtering.
IP Menu
*2
Configures the subnets for each VLAN group, global configuration for unicast
and multicast protocols, BOOTP/DHCP relay, static ARP table entries, static
routes and the default route.
Security
Restrict access through MAC address or IP address
*2