Planet Technology WGS3-404 - Manual (Page 240)

WGS3 Layer 3 Switch User’s Manual - 232 -
6.2 Layer 3 Switching
The two major functions provided by a Layer 3 switch include IP Switching and Routing Path
Management. When the switch is set to multilayer mode, it acts as a routing switch, with support for
standard IP routing and the ability to pass traffic between VLANs as required. However, when the switch
is first set to multilayer mode, no default routing is defined. As with all traditional routers, the routing
function must first be configured to work. (RIP).
6.2.1 Initial Configuration
In the default configuration, all ports belong to the same virtual LAN and the switch provides only Layer 2
functionality. So you should first group all the ports that belong to the same subnet into virtual LANs. By
separating the switch into different VLANs, the network is partitioned into subnetworks that are
disconnected at Layer 2. Network traffic within the same subnet is still switched using Layer 2 switching.
And the VLANs can now be interconnected (only as required) with Layer 3 switching. Each VLAN
represents a virtual interface to Layer 3. You just need to provide the network addresses for each virtual
interface, and the traffic between different subnetworks will be routed by Layer 3 switching.
VLAN Configuration for Layer 3
Note: When operating the switch in multilayer mode, all ports should be defined as untagged, and no
VLANs can overlap. You should also assign the same default PVID to the ports at both ends of a link if
the VLAN must cross the switches. (See “VLAN Tagging” configuration.) These limitations will be
removed for future firmware versions.