Planet Technology WGS3-404 - Manual (Page 184)

WGS3 Layer 3 Switch User’s Manual - 176 -
5.7.5 Configuring IP Settings
If this switch is WGS3-404 or WGS3-2620 in multilayer mode, the IP Menu will be displayed.
Use this menu to configure the IP subnets for each VLAN on your switch, the unicast and multicast
routing protocols, static ARP entries, static IP routes, and the default IP route.
Parameter
Description
Subnet
Configuration
IP Subnet Configuration – Specifies the IP interface for VLANs configured on this
switch, including the subnet address and routing protocols.
Port Group Configuration – See “5.7.3.2 VLAN Table Configuration”.
Protocol
Configuration
Configures ARP timeout, enables Proxy ARP, sets the preferred servers for
BOOTP/DHCP Relay, as well as enabling/configuring unicast and multicast protocols
globally for this switch.
Static ARP
Configuration
Used to map an IP address to a specific physical MAC address.
Static Route Used to configure static routes to other IP networks, subnetworks, or hosts.
Default Route Defines the router to which this switch will forward all traffic for unknown networks.