Planet Technology WGS3-404 User Manual
Page 3
WGS3 Layer 3 Switch User’s Manual
• Wear an anti-static wrist strap or take other suitable measures to prevent electrostatic discharge
whenever handling this equipment.
• When connecting to a power outlet, connect the field ground lead on the triple power plug to a
valid earth ground line to prevent electrical hazards.
FCC Compliance Statement
This equipment generates and uses radio frequency energy and if not installed and used properly, that is,
in strict accordance with the instructions provided with the equipment, may cause interference to radio
and TV communication. The equipment has been tested and found to comply with the limits for a Class A
computing device in accordance with the specifications in Subpart B of Part 15 of FCC rules, which are
designed to provide reasonable protection against such interference in a residential installation. However,
there is no guarantee that interference will not occur in a particular installation. If you suspect this
equipment is causing interference, turn your Ethernet Switch on and off while your radio or TV is showing
interference, if the interference disappears when you turn your Ethernet Switch off and reappears when
you turn it back on, there is interference being caused by the Ethernet Switch.
You can try to correct the interference by one or more of the following measures:
Reorient the receiving radio or TV antenna where this may be done safely.
To the extent possible, relocate the radio, TV or other receiver away from the Switch.
Plug the Ethernet Switch into a different power outlet so that the Switch and the receiver are on
different branch circuits.
If necessary, you should consult the place of purchase or an experienced radio/television technician for
additional suggestions.
CE Mark Warning
In a domestic environment, this product may cause radio interference, in which case the user may be
required to take adequate measures.
Revision
User's Manual for PLANET Layer 3 Gigabit Ethernet Switch
Model: WGS3-404, WGS3-2620
Rev: 2.0 (October. 2002)
Part No. EMQ-WGS3-v1