Powerware 9125 Two-in-One UPS 6000 VA - Manual (Page 23)

INSTALLATION
EATON Powerware ® 9125 Two-in-One UPS (5000/6000 VA) User’s Guide S 164201513 Rev B
www.powerware.com
17
5. If you are installing the UPS in a tower configuration, continue to
the following section, “Tower Setup.”
If the UPS is in a rack and you are installing an optional EBM,
continue to “EBM Installation” on page 19; otherwise, continue to
“Plug-Receptacle UPS Installation” on page 21 or “Hardwired UPS
Installation” on page 24.
Tower Setup
The UPS and any optional cabinets must be stabilized with pedestals or
joining brackets. The setup varies depending on the number of cabinets
you are installing:
1. For one cabinet, the pedestals must be installed (purchased
separately). Complete Steps 2 through 4.
For two or more cabinets, the pedestals are not installed. Skip to
Step 5 to install the supplied joining brackets.
2. Place the UPS horizontally so that the left end of the cabinet is
accessible (see Figure 5).
3. Align the UPS pedestals over the holes on the end of the UPS as
shown in Figure 5. Secure the pedestals with the supplied screws.
Figure 5. Installing the UPS Pedestals
4. Carefully position the cabinet upright (see Figure 6).
Continue to “Plug-Receptacle UPS Installation” on page 21 or
“Hardwired UPS Installation” on page 24.