Powerware 9125 Two-in-One UPS 6000 VA - Manual (Page 43)

EATON Powerware ® 9125 Two-in-One UPS (5000/6000 VA) User’s Guide S 164201513 Rev B
www.powerware.com
37
Chapter 6 Communication
The Powerware 9125 UPS is equipped with a USB port, a DB-9
communication port, and an X-Slot communication bay (see Figure 18).
Either the USB port or the DB-9 communication port may be used to
monitor the UPS; however, they cannot operate simultaneously.
The X-Slot communication bay can accommodate any Powerware X-Slot
card and can operate simultaneously with the USB port or DB-9
communication port.
USB Port DB-9 Communication Port
X-Slot Communication Bay
Figure 18. Communication Options
USB Port
The UPS can communicate with a USB-compliant computer using
Powerware LanSafe
t Power Management Software (v5.0.1 or higher).
To establish communication between the UPS and a computer:
1. Connect the USB cable to the USB port on the UPS rear panel (see
Figure 18).
Connect the other end of the USB cable to the USB port on your
computer.
2. Install the Powerware LanSafe software and USB drivers according
to the instructions provided with the Software Suite CD.