NCR S26 - Manual (Page 105)

Using the EISA Configuration Utility
NCR S26 Hot Plug Server User Guide 5-15
6. Select “Step 2: Add or remove boards” and press Enter to display the
screen as shown in the figure below.
Figure 5-7. Add or Remove Boards
Step 2: Add or remove boards
Listed are the board and options detected in your computer.
Press F10 when you have completed this step.
Press INSERT to add the boards or options which could not be
detected or which you plan to install.
Press DEL to remove the highlighted board from your configuration.
Press F7 to move the highlighted board to another slot.
Add = INSERT <Remove = DEL> <Move = F7> <Done = F10>
System
EISA 1
EISA 2
EISA 3
PCI 1
PCI 2
PCI 3
PCI 4
PCI 5
Embedded PCI SCSI Controller
Embedded PCI VGA Controller
NCR 3426 Dual Pentium System
(Empty)
(Empty)
(Empty)
(Empty)
(Empty)
(Empty)
(Empty)
(Empty)
The screen contains the configuration data that the ECU read from your
CFG file. It includes the number of EISA slots and device controllers
detected.
7. If you want to add or have already added a board, highlight a slot and
press Insert to select an option from the list that displays.
8. Press F10 when done.
9. Follow steps 4 to 13 in the “Configuring Your Computer Initially” section
to complete your configuration.