NCR S26 - Manual (Page 83)

System Security
NCR S26 Hot Plug Server User Guide 4-27
Onboard PS/2 Mouse (IRQ 12)
This parameter enables or disables the onboard PS/2 mouse. When set to
Enabled, it permits you to use the onboard PS/2 mouse assigned with IRQ12.
When set to Disabled, it deactivates the mouse and frees IRQ12 for the use of
other devices.
Setup Password
The Setup password prevents unauthorized access to the BIOS Utility.
Note: Set jumper JP1 on the system board to pins 1-2 to enable the password
function.
Setting a Password
1. Highlight the Setup Password parameter and press the left- or right-arrow
key. The password prompt appears.
2. Type a password. The password may consist of up to seven characters.
CAUTION: Be careful when typing your password because the
characters do not appear on the screen.
3. Press Enter. A screen message asks you to retype the password to verify
your first entry.
4. Retype the password then press Enter.
After setting the password, the system automatically sets the Setup Password
parameter to Present. The next time you want to enter the BIOS utility, you
must type your Setup password.
If You Forget the Password
If you forget your password, you must reset the configuration values stored in
CMOS to their default values. Should this happen, call your dealer for
assistance.