NCR S26 - Manual (Page 124)

Sample Standard Configuration
C-6 Sample Configurations
Power Saving Configuration
1. Select Power Saving Configuration. Set the parameters as follows:
Power Management Mode... [Disabled]
2. Press Esc to return to the BIOS Setup main menu.
Remote Diagnostic Configuration
1. Select Remote Diagnostic Configuration. Set the parameters as follows:
RDM Mode Number [Disabled]
Note: Refer to the NCR ValuePlus CD for BackOffice, Release 4.2, User’s
Guide for information on configuring this for remote diagnostic management.
2. Press Esc to return to the BIOS Setup main menu.
System Security
1. Select System Security. On Page 1, set the parameters as follows:
Disk Drive Control
Diskette Drive [Normal]
Hard Disk Drive [Normal]
System Boot Drive [Drive A Then C]
On Board Communication Ports
Serial Port 1 Base Address [3F8h]
Serial Port 2 Base Address [2F8h]
Parallel Port Base Address [3BCh (IRQ 7)]
Operation Mode [Stndrd PP (SPP)] Mode
ECP DMA Channel [ - ]