Installing drives, Removing the upper front panel cover and frame – NCR S26 User Manual
Page 50
Advertising
Installing Drives
3-18
Adding and Replacing Components
Installing Drives
CAUTION: Read the “ESD Precautions” section earlier in this chapter
before proceeding.
This section describes in detail how to install disk drives in the system.
Removing the Upper Front Panel Cover and Frame
When installing drives on the 5.25-inch drive bays, you have to remove the
upper front panel cover and frame. Follow these steps:
1. Open the lower front panel cover.
2. Press the latch under the upper front panel and pull as shown in the figure
below.
Figure 3-8. Removing the Upper Front Panel Cover and Frame
Advertising