NEC DT100 - Manual (Page 12)

E-7
● Notice
This equipment has been tested and found to comply with the limits for a Class
A digital device, pursuant to Part 15 of the FCC Rules. These limits are de-
signed to provide reasonable protection against harmful interference when the
equipment is operated in a commercial environment. This equipment generates,
uses and can radiate radio frequency energy and, if not installed and used in
accordance with the instruction manual, may cause harmful interference to radio
communications. Operation of this equipment in a residential area is likely to
cause harmful interference in which case the user will be required to correct the
interference at his own expense.
● FCC WARNING
Changes or modifications not expressly approved by the party responsible for
compliance could void the user's authority to operate the equipment.
For FCC compatibility, use only the attached cable to connect to external
devices.
● WARNING
This is a Class A product. In a domestic environment this product may cause
radio interference in which case the user may be required to take adequate
measures.
For EN55022 compatibility, use only the attached cable to connect to external
devices.
3. GSGV Acoustic Noise Information Ordinance:
The sound pressure leveI is Iess than 70dB (A) according to ISO 3744or ISO 7779.
In UK, a BS approved power cable with moulded plug has a BIack (five Amps) fuse installed for
use with this equipment. If a power cable is not supplied with this equipment please contact your
supplier.
CAUTION: To turn off main power, be sure to remove the plug from power outlet. The power,
outlet socket should be installed as near to the equipment as possible, and should be easily
accessible.
DOC compliance Notice
This Class A digital apparstus meets all requirements of the Canadian Interference-Causing
Equipment Regulations.
For Europe For North America
Two types of power cables are supplied with the projector: Three-pin type for U.S.A and Canada;
and Two-pin type for Europe.
DO NOT REMOVE ANY SCREWS except the lamp cover screw and two lamp unit screws. You
could receive an electric shock.