NEC DT100 - Manual (Page 21)

E-16
Installation
■ Installation Procedure
■Adjustable feet
Use the adjustable feet to adjust the position or inclination of the projected image.
Press the right and left tilt adjust button to lift the front side of the unit and let go your hold
when the desired height is reached. Rotate the bottom of the tilt foot for fine adjustment.
Rotate counterclockwise to extend and clockwise to retract the tilt foot.
CAUTION
• Adjust both feet so that both sides of the front of the projector remain level.
Failure to do so may result in the projector sliding or falling and becoming damaged.
• Air for cooling is forcibly taken in through the air vent A at the bottom of the unit. If the vent is blocked by paper or
cloth, the internal temperature increases, resulting in accidents or malfunctions.
• The rubber feet may soil the floor depending on the materials.
Determine the
installation
location and
image size.
Put your
projector in
place.
Connect
external devices.
Set up a screen END
PC, video source, etc. See page E-17,
"Projection Distance
and Image Size."
UP DOWN
Adjustable feet
Tilt adjust button