NEC N8406-022A - Manual (Page 41)

Command Line Interface 41
Trunk group information
Command: /info/l2/trunk
Trunk group 1, Enabled
Protocol - Static
port state:
20: forwarding
21: forwarding
22: forwarding
23: forwarding
24: forwarding
When trunk groups are configured, you can view the state of each port in the various trunk groups.
Layer 3 information
Command: /info/l3
[Layer 3 Menu]
arp - ARP Information Menu
ip - Show IP information
igmp - Show IGMP Snooping Multicast Group information
dump - Dump all layer 3 information
The following table describes the Layer 3 Information Menu options.
Table 29 Layer 3 information menu options
Command Usage
arp Displays the Address Resolution Protocol (ARP) Information Menu.
ip Displays IP Information. IP information, includes:
•
IP interface information: Interface number, IP address, subnet mask, VLAN number, and
operational status.
•
Default gateway information: Metric for selecting which configured gateway to use,
gateway number, IP address, and health status
•
IP forwarding information: Enable status, lnet and lmask
•
Port status
igmp Displays IGMP Information Menu.
dump Dumps all switch information available from the Layer 3 Menu (10K or more, depending on
your configuration).
If you want to capture dump data to a file, set your communication software on your
workstation to capture session data prior to issuing the dump commands.