NEC N8406-022A - Manual (Page 78)

Command Line Interface 78
Port configuration
Command: /cfg/port <port number>
[Port 1 Menu]
speed - Set link speed and force full duplex mode
fctl - Set flow control
auto - Set auto negotiation
name - Set port name
ena - Enable port
dis - Disable port
cur - Display current port configuration
This menu enables you to configure settings for individual switch ports. This command is enabled by default.
NOTE: Port 19 is a port for switch management interface (interface 256). Cross-link ports (17-18) are not
available on the SmartPanel software.
The following table describes the Port Configuration Menu options.
Table 80 Port Configuration Menu options
Command Description
speed 10|100|1000|any Sets the link speed. Not all options are valid on all ports. The choices
include:
•
10 Mb/s
•
100 Mb/s
•
1000 Mb/s
•
“any,” for automatic detection (default)
Note: Ports 1-16 are set to 1000 Mb/s, and cannot be changed.
fctl rx|tx|both|none Sets the flow control. The choices include:
•
Receive (rx) flow control
•
Transmit (tx) flow control
•
Both receive and transmit flow control (default)
•
No flow control
auto on|off Enables or disables auto-negotiation for the port. The default is
enabled.
name <1-64 characters>|none Set the port name.
ena Enables the port.
dis Disables the port. To temporarily disable a port without changing its
configuration attributes, see the “Operation Menu” section.
cur Displays current port parameters.
Spare Ports Group configuration
Command: /cfg/spgroup
[Spare Ports Group Menu]
addport - Add ports to the group
cur - Display current group configuration
Use these menu options to set unused ports to Spare Ports Group. Set the ports, which Port Group 1-5 do not
contain, to Spare Ports Group.
The following table describes the Spare Ports Group Configuration menu options.
Table 81 Spare Ports Group Configuration menu options
Command Description
add <port number> Adds the specified port to Spare Ports Group.
cur Displays the current Spare Ports Group configuration.