NEC N8406-022A - Manual (Page 82)

Command Line Interface 82
Boot Options Menu
Introduction
You must be logged in to the switch as the administrator to use the Boot Options Menu.
The Boot Options Menu provides options for:
•
Selecting a switch software image to be used when the switch is next reset.
•
Selecting a configuration block to be used when the switch is next reset.
•
Downloading or uploading a new software image to the switch via FTP or TFTP.
Menu information
Command: /boot
[Boot Options Menu]
image - Select software image to use on next boot
conf - Select config block to use on next boot
gtimg - Download new software image via FTP/TFTP
ptimg - Upload selected software image via FTP/TFTP
reset - Reset switch
cur - Display current boot options
Each of the Boot Options Menu commands is discussed in greater detail in the following sections.
Updating the switch software image
The switch software image is the executable code running on the switch. A version of the image ships with the
switch, and comes pre-installed on the device. As new versions of the image are released, you can upgrade the
software running on the switch.
Upgrading the software image on the switch requires the following:
•
Loading the new image onto a FTP or TFTP server on your network
•
Downloading the new image from the FTP or TFTP server to the switch
•
Selecting the new software image to be loaded into switch memory the next time the switch is reset
Downloading new software to the switch
The switch can store up to two different software images, called image1 and image2, as well as boot software,
called boot. When you download new software, you must specify where it should be placed: either into image1,
image2, or boot.
By default, the software for conventional Layer2 switch mode is stored in image1 and the software for SmartPanel
mode is stored in image2.
To download new software to the switch, you will need the following:
•
The image or boot software loaded on a FTP or TFTP server on your network
•
The IP address of the FTP or TFTP server
•
The name of the new software image or boot file
When the above requirements are met, use the following procedure to download the new software to the switch.
1. At the Boot Options# prompt, enter:
Boot Options# gtimg
2. Enter the name of the switch software to be replaced:
Enter name of switch software image to be replaced
["image1"/"image2"/"boot"]: <image>
3. Enter the IP address of the FTP or TFTP server:
Enter IP address of FTP/TFTP server: <IP address>
4. Enter the name of the new software file on the server:
Enter name of file on FTP/TFTP server: <filename>