NEC N8406-022A - Manual (Page 61)

Command Line Interface 61
Viewing pending changes
You can view all pending configuration changes by entering diff at any CLI prompt:
# diff
You can view all pending configuration changes that have been applied but not saved to flash memory by entering
diff flash
at any CLI prompt:
# diff flash
Applying pending changes
To make your configuration changes active, you must apply them. To apply configuration changes, enter the
following command at any prompt:
# apply
NOTE: All configuration changes take effect immediately when applied.
Reverting changes
The revert command removes configuration changes that have been made, but not applied. Enter revert apply
to remove all changes that have not been saved:
# revert
Saving the configuration
In addition to applying the configuration changes, you can save them to flash memory on the switch.
IMPORTANT: If you do not save the changes, they will be lost the next time the system is rebooted.
To save the new configuration, enter the following command at any prompt:
# save
When you save configuration changes, the changes are saved to the active configuration block. The configuration
being replaced by the save is first copied to the backup configuration block. If you do not want the previous
configuration block copied to the backup configuration block, enter the following instead:
# save n
You can decide which configuration you want to run the next time you reset the switch. Your options include:
•
The active configuration block
•
The backup configuration block
•
Factory default configuration block
You can view all pending configuration changes that have been applied but not saved to flash memory using the
diff flash command. It is a global command that can be executed from any prompt.
For instructions on selecting the configuration to run at the next system reset, see the “Selecting a configuration
block” section in the “Boot Options Menu” chapter.