NEC N8406-022A - Manual (Page 59)

Command Line Interface 59
NTP statistics
Command: /stats/ntp
NTP statistics:
Primary Server:
Requests Sent: 17
Responses Received: 17
Updates: 1
Secondary Server:
Requests Sent: 0
Responses Received: 0
Updates: 0
Last update based on response from primary server.
Last update time: 18:04:16 Tue Mar 13, 2006
Current system time: 18:55:49 Tue Mar 13, 2006
The switch uses NTP (Network Timing Protocol) version 3 to synchronize the switch’s internal clock with an atomic
time-calibrated NTP server. With NTP enabled, the switch can accurately update its internal clock to be consistent
with other devices on the network and generates accurate syslogs.
The following table describes the NTP statistics:
Table 56 NTP statistics
Statistics Description
Primary Server Requests Sent: The total number of NTP requests the switch sent to the primary
NTP server to synchronize time.
Responses Received: The total number of NTP responses received from the
primary NTP server.
Updates: The total number of times the switch updated its time based on the NTP
responses received from the primary NTP server.
Secondary Server Requests Sent: The total number of NTP requests the switch sent to the
secondary NTP server to synchronize time.
Responses Received: The total number of NTP responses received from the
secondary NTP server.
Updates: The total number of times the switch updated its time based on the NTP
responses received from the secondary NTP server.
Last update based on
response from primary
server Last update of time on the switch based on either primary or secondary NTP
response received.
Last update time The time stamp showing the time when the switch was last updated.
Current system time The switch system time when the command /stats/ntp was issued.
Statistics dump
Command: /stats/dump
Use the dump command to dump all switch statistics available from the Statistics Menu (40K or more, depending
on your configuration). This data can be used to tune or debug switch performance.
If you want to capture dump data to a file, set your communication software on your workstation to capture session
data prior to issuing the dump commands.