Projecting an image (basic operation), 1) turning on the projector, 1 turning on the projector – NEC NP410 User Manual
Page 35
26
3. Projecting an Image (Basic Operation)
This section describes how to turn on the projector and to project a picture onto the screen.
1 Turning on the Projector
NOTE:
• The projector has two power switches: a main power switch and a
(POWER) button (POWER ON and OFF on the remote
control).
• When plugging in or unplugging the supplied power cable, make sure that the main power switch is pushed to the off () posi-
tion. Failure to do so may cause damage to the projector.
1. Remove the lens cap
• Do not remove the lens cap by pulling on the string. Doing
so can cause mechanical damage to the part around the
lens.
2. To turn on the main power to the projector, press the
Main Power switch to the on position ( I ).
The projector will go into standby mode. When in standby
mode, the POWER indicator will light orange and the STA-
TUS indicator will light green when [NORMAL] is selected
for [STANDBY MODE].
See the Power Indicator section.(
→ page
)
FO
CUS
FOC
US
STATUS
LAMP
AUTO ADJ.
SOURCE