4) changing eco mode, Changing eco mode, Convenient features – NEC NP410 User Manual
Page 50
41
4. Convenient Features
Changing Eco Mode
This feature enables you to select two brightness modes of the lamp:
OFF and ON modes. The lamp life can be extended by turning on the [ECO MODE].
[ECO MODE]
Description
Status of LAMP indicator
[OFF]
This is the default setting (100% Brightness).
Off
STATUS
LAMP
[ON]
Select this mode to increase the lamp life (approx.
70% Brightness on NP610/NP510W/NP410W/
NP610S/NP510WS and approx. 80% Brightness on
NP510/NP410/NP405/NP310/NP305).
Steady Green light
STATUS
LAMP
To turn on the [ECO MODE], do the following:
1. Press the ECO MODE button on the remote control to display [ECO MODE] screen.
2. Use the
or button to select [ON].
3. Press the ENTER button.
To change from [ON] to [OFF], Go back to Step 2 and select [OFF]. Repeat Step 3.
NOTE:
• The [ECO MODE] can be changed by using the menu.
Select [SETUP]
→ [GENERAL] → [ECO MODE].
• The lamp life remaining and lamp hours used can be checked in [USAGE TIME]. Select [INFO.]
→[USAGE TIME].
• The projector is always in [ON] for 90 seconds after the lamp is turned on and while the POWER indicator is blinking green. The
lamp condition will not be affected even when [ECO MODE] is changed.
• After a lapse of 1 minute from when the projector displays a blue, black or logo screen, [ECO MODE] will automatically switch to
[ON]. The projector will return to the [OFF] once a signal is accepted.
• If the projector is overheated in [OFF] mode, there may be a case where the [ECO MODE] automatically changes to [ON] mode
to protect the projector. When the projector is in [ON] mode, the picture brightness decreases. When the projector comes back
to normal temperature, the [ECO MODE] returns to [OFF] mode.
Thermometer symbol [ ] indicates the [ECO MODE] is automatically set to [ON] mode because the internal temperature is too
high.
2. Press the
button.
The area of the magnified image will be moved
3. Press the MAGNIFY (−) button.
Each time the MAGNIFY (−) button is pressed, the image is re-
duced.
NOTE:
• The image will be enlarged or reduced at the center of the screen.
• Displaying the menu will cancel the current magnification.
ENTER
EXIT
MENU
UP
MAGNIFY
PAGE
OFF
POWER
ON
AV-MUTE
DOWN