NEC NP410 User Manual

Page 82

Advertising

5. Using On-Screen Menu

Selecting Communication Speed [COMMUNICATION SPEED]

This feature sets the baud rate of the PC Control port (D-Sub 9P). It supports data rates from 4800 to 19200 bps. The
default is 19200 bps. Select the appropriate baud rate for your equipment to be connected (depending on the equip-
ment, a lower baud rate may be recommended for long cable runs).

NOTE: Your selected communication speed will not be affected even when [RESET] is done from the menu.

Setting ID to the Projector [CONTROL ID]
(Available only when the optional remote control NP02RC is used)

You can operate multiple projectors separately and independently with the single remote control that has the CONTROL
ID function. If you assign the same ID to all the projectors, you can conveniently operate all the projectors together
using the single remote control. To do so, you have to assign an ID number to each projector.

CONTROL ID NUMBER .......Select a number from 1 to 254 you wish to assign to your projector.
CONTROL ID .......................Select [OFF] to turn off the CONTROL ID setting and select [ON] to turn on the CONTROL ID set-

ting.

NOTE:

• Selecting [ON] for [CONTROL ID] will make the remote control supplied with the projector inoperable. The buttons on the projector

cabinet can be used. Neither can you operate the projector by using the optional remote control NP01RC that does not has the

CONTROL ID function.

• Your setting will not be affected even when [RESET] is done from the menu.

• Pressing and holding the ENTER button on the projector cabinet for 10 seconds will display the menu for canceling the Control

ID.

Assigning or Changing the Control ID
1. Turn on the projector.
2. Press the ID SET button on the remote control (NP02RC).
The CONTROL ID screen will be displayed.

If the projector can be operated with the current remote control ID, the [ACTIVE] will be displayed. If the projector

cannot be operated with the current remote control ID, the [INACTIVE] will be displayed. To operate the inactive
projector, assign the control ID used for the projector by using the following procedure (Step 3).

3. Press one of numeric keypad buttons while pressing and holding the ID SET button on the remote control

(NP02RC).

Example:

To assign “3”, press the “3” button on the remote control.
No ID means that all the projectors can be operated together with a single remote

control. To set “No ID”, enter “000” or press the CLEAR button.

TIP: The range of IDs is from 1 to 254.

4. Release the ID SET button.
The updated CONTROL ID screen will be displayed.
NOTE: The IDs can be cleared in a few days after the batteries are run down or removed.

OFF

COMPUTER

VIDEO

S-VIDEO

VIEWER NETWORK

HDMI

PIP

MAGNIFY

VOLUME

PICTURE

LAMP MODE

ASPECT

AV-MUTE

3D REFORM

FREEZE

ID SET

LENS SHIFT

FOCUS

/ZOOM

HELP

PAGE

L-CLICK

R-CLICK

EXIT

COMPONENT

AUTO ADJ.

ENTER

DOWN

POWER

CLEAR

OFF