NEC M350X - Manual (Page 124)

114
6. Installation and Connections
Attaching the Optional Cable Cover (NP01CV)
An optional cable cover (NP01CV) is available for hiding cables.
The NP01CV cable cover is designed for use with the M420X, M420XV, M350XS, M300XS, M260XS, M300WS, and
M260WS.
CAUTION:
• Be sure to tighten the screws after attaching the cable cover. Failure to do so may cause the cable cover to come
off and fall, resulting in injury or damage to the cable cover.
• Do not put bundled cables in the cable cover. Failure to do so may damage the power cord, resulting a fire.
Attaching the cable cover
Attach the cable cover after installing the projector on the ceiling and connecting cables.
Tool needed for attaching:
• Phillips screwdriver (plus-head)
1. Align two tabs on the outside of the cable cover with grooves of the projector and push the top end.
1
2
1
Tabs
• At the same time two tabs on the inside of the cable cover will be engaged in the responding grooves of the
projector.
NOTE:
• Be careful not to get cables caught in between the cable cover and the projector.
2. Tighten the cable cover screws.
• Be sure to tighten the screws.
1
2
Removing the cable cover
1. Loosen the cable cover screws until the Phillips screwdriver goes into a freewheeling condition
2. Remove the cable cover.
Push up the cable cover slightly and rotate it to release.