NEC M350X - Manual (Page 72)

62
4. Using the Viewer
Removing the USB memory from the pro-
jector
1. Select the VIEWER start screen.
Press the EXIT button with no menu displayed.
2. Remove the USB memory from the projector.
Make sure that the LED on the USB memory is not
flashing before removing the USB memory.
NOTE: If you remove the USB memory from the projector with
a slide displayed, the projector may not operate correctly. If
this happens, turn off the projector and unplug the power
cord. Wait 3 minutes, then connect the power cord, and turn
on the projector.
Exiting the Viewer
1. Press the MENU button with the slide screen or
the thumbnail screen displayed.
The control bar or the pop-up menu will be dis-
played.
2. Press the MENU button again.
The on-screen menu will be displayed.
3. Select a source other than [VIEWER] and press
the ENTER button.
The Viewer will be exited.
TIP: To exit the Viewer using the remote control, select a source
other than [VIEWER].
WIRELESS
WIRELES
S