NEC M350X - Manual (Page 40)

30
3. Convenient Features
 Changing Eco Mode/Checking Energy-Saving Effect
Using Eco Mode [ECO MODE]
The ECO MODE (ECO1 and ECO2) increases lamp life, while lowering power consumption and cutting down on CO
2
emissions.
Four brightness modes of the lamp can be selected: [OFF], [AUTO ECO], [ECO1] and [ECO2] modes.
[ECO MODE] Description Status of LAMP indicator
[OFF] This is the default setting (100% Brightness). Off
[AUTO ECO] Lamp power consumption will be changed between
[OFF] and [ECO1] automatically according to picture
level
NOTE: A bright gradation may be less visible depending on
the image.
Steady
Green light
[ECO1] Low lamp power consumption (approx. 75% Brightness
on M350X/M300W/M420X/M420XV/M350XS/M300XS/
M300WS/M260WS and approx. 80% Brightness on
M300X/M260X/M230X/M260W/M260XS).
[ECO2] (M300X,
M260X, and
M260XS only) Lower lamp power consumption than [ECO1] mode (ap-
prox. 50% Brightness on M300X/M260X/M260XS)
To turn on the [ECO MODE], do the following:
1. Press the ECO Button on the remote control to display [ECO MODE] screen.
2. Press the ECO button again to select a mode you wish.
• Each time the ECO button is pressed, the choices will be changed:
OFF
→ AUTO ECO → ECO1 (→ ECO2) → OFF
• When the projector is in ECO mode, the LAMP indicator will light green.
TIP:
• The leaf symbol at the bottom of the menu shows the current selection of ECO mode.
2. Press the  button.
The area of the magnified image will be moved
3. Press the D-ZOOM (−) button.
Each time the D-ZOOM (−) button is pressed, the image is reduced.
NOTE:
• The image will be enlarged or reduced at the center of the screen.
• Displaying the menu will cancel the current magnification.