Roland SH-201 - Manual (Page 36)

36
Creating sounds
fig.FILTER-RESONANCE-knob
This boosts the sound in the region near the filter cutoff frequency,
adding a distinctive character to the sound.
• Turning the knob toward the right will boost the sound in the
region near the cutoff frequency, producing a more strongly
distinctive sound.
• Turning the knob toward the left will remove the boost from the
sound in the region near the cutoff frequency, producing a less
distinctive sound.
* When the filter TYPE is “BYPASS,” turning the knob will not affect the
sound.
If you turn the RESONANCE knob far toward the right, oscillation may occur and the sound may not stop at all.
To stop the oscillation, turn the RESONANCE knob toward the left.
fig.FILTER-KEYFOLLOW-knob
This causes the filter cutoff frequency to change according to the key
you play.
• Turning the knob toward the right will cause the cutoff frequency to
rise as you play upward on the keyboard and fall as you play lower
on the keyboard.
• Turning the knob toward the left will cause the cutoff frequency to
fall as you play upward on the keyboard and rise as you play lower
on the keyboard.
• At the center position (0), the cutoff frequency will not be affected by
the position of the key you play.
* When the filter TYPE is “BYPASS,” turning the knob will not affect the
sound.
RESONANCE knob
KEY FOLLOW knob
LPF BPF HPF
parameter value
level
Cutoff frequency
frequency
High
Low
C4 C3 C2 C5 C6
0
+50
+100
+200
-50
-100
-200
o
-1
-2
+1
+2
Cutoff frequency
(Octave)
Key
parameter value
High
Low
SH-201_r_e.book 36 ページ ２００６年４月２７日 木曜日 午前１１時２８分