Ricoh Aficio Copy Machine 180 - Manual (Page 270)

NetWare 3.x - Advanced Settings
35
3
Setting Up as Remote Printer
A
Log in to the file server as a Supervisor or a Supervisor equivalent.
B
Run the NIB Setup Tool.
Reference
“Running the NIB Setup Tool”
⇒
P.28.
C
Click [Property Sheet] and click [OK] .
The Browse dialog of the Network Interface Board appears.
D
Click [IPX protocol] .
E
Select the IPX address of the Network Interface Board which is to be con-
figured by clicking it, and click
[Next >] .
Note
❒ If you don't know which Network Interface Board you are configuring,
print the Configuration Page using the printer's operation panel, and select
the MAC address that is on the page.
F
Confirm that the MAC and IPX addresses are correct, and click [Finish] .
[NIB Setup Tool] window appears.
G
Click [Configure] .
The property sheet appears.
H
Click the [NetWare] tab, and make the following settings.
A In the
[Print Server Name] box, input the name of the print server.
B In the
[File Server Name] box, input the name of the file server in which a
print server is to be created.
Clicking [Browse] , you can select a file server among those listed in the
Browse dialog.
C In the
[Print Server Operation Mode] group, click [As Remote Printer] .
D In the
[Remote Printer No.] box, input the printer number.
Important
❒ Use the same printer number as that to be created in the printer server.
E Click
[OK] to close the property sheet.
F After a confirmation dialog appears, click
[OK] .
I
In the [NIB] menu, click [Exit] to exit the NIB Setup Tool.