RuggedCom RuggedRouter RX1000 - Manual (Page 143)

Chapter 13 – Configuring Dynamic Routing
Link Detect
When link detect is enabled for an OSPF/RIP active interface, OSPF or RIP will be
notified when the interface goes down and will stop advertising subnets associated
with that interface. OSPF and RIP will resume advertising the subnet when the link
is restored. This allows OSPF and RIP to detect link failures more rapidly (as the
router does not have to wait a dead interval to time out). Link Detect will also cause
“ redistributed” routes to start and stop being advertised based upon the status of their
interface links.
Configuring OSPF Link Costs
Link cost is used when multiple links can reach a given destination, to determine
which route to use. OSPF will (by default) assign the same cost to all links unless
provided with extra information about the links. Each interface is assumed to be
10Mbit unless told otherwise in the Core Interface configuration.
The reference bandwidth for link cost calculations is 100Mbit by default in the OSPF
Global Parameters. The reference bandwidth divided by the link bandwidth gives the
default cost for a link, which by default is 10. If a specific bandwidth is assigned to
each link, the costs will take this into account.
It is also possible to manually assign a cost to using a link in the OSPF Interface
Configuration for each interface for cases where the speed of the link is not desired as
the method for choosing the best link.
OSPF Authentication
OSPF authentication is used when it is desirable to prevent unauthorized routers from
joining the OSPF network. By enabling authentication and configuring a shared key
on all the routers, only routers which have the same authentication key will be able to
send and receive advertisements within the OSPF network. Authentication adds a
small overhead due to the encryption of messages, so is not to be preferred on
completely private networks with controlled access.
RIP Authentication
RIP authentication is used when it is desirable to prevent unauthorized routers from
joining the network. RIP authentication is supported by per-interface configuration or
the use of key-chains. Separate key chains spanning different groups of interfaces
and having separate lifespans are possible. By enabling authentication and
configuring a shared key on all the routers, only routers which have the same
authentication key will be able to send and receive advertisements within the RIP
network.
OSPF And Antispoofing
Antispoofing is the process of discarding packets arriving on an interface because
they match the subnet of another configure interface. This is not a normal occurrence
in conventional routing. This situation can arise in OSPF, when routers are multiply
connected. If for example two routers are connected by lower speed wan and higher
speed Ethernet links, packets on subnets native to the wan will still be forwarded via
Ethernet because of cost. If antispoofing is enabled, the packet will be discarded at
the peer OSPF router.
RuggedCom 141