Introduction, Access methods, Accounts and password management – RuggedCom RuggedRouter RX1000 User Manual
Page 29: Default configuration
Chapter 1 – Setting Up And Administering The Router
Chapter 1 – Setting Up And Administering The
Router
Introduction
This chapter familiarizes the user with the RuggedCom Serial Console interface, the
RuggedRouter
Setup script and signing on to the Web interface. This chapter
describes the following procedures:
•
Running the Setup Script
•
Signing on the Web Interface
•
Signing on to the Command Prompt
•
Restoring the default configuration
Access Methods
You can access the router through the console, Ethernet ports, WAN ports and the
modem port.
Accounts And Password Management
The router provides an “rrsetup” account which provides a shell that quickly
configures such items as passwords, addresses, date/time and services offered by the
router. It is very useful to sign-in to this shell first, harden the router, and configure
network addresses in order that the router be reachable from the network through
Web Management. The rrsetup password should be changed, recorded securely
and restricted to qualified personnel.
The root account provides a superuser capability for SSH shell access and the Web
server. The password should be changed, recorded securely and restricted to
qualified personnel.
The root and rrsetup accounts may be also be managed through radius authentication.
The Web management agent can be accessed through the root account. It may also be
accessed through a number of radius accounts via radius authentication. This offers
the advantage of attributing actions in logs to the specific user, as opposed to the root
user.
Default Configuration
Your RuggedRouter
is shipped from the factory with the following defaults:
•
Ethernet ports are enabled and have an address of 192.168.X.1 where X
is the port number,
•
WAN and modem ports are disabled,
•
IRIG-B output ports are disabled,
•
Setup account “rrsetup”, password “admin”,
•
Superuser account “root”, password “admin”,
•
SSH and Web Management interfaces are enabled by default. All other
services (including Serial Protocol Server, DHCP server, NTP server, End to
RuggedCom 27