RuggedCom RuggedRouter RX1000 - Manual (Page 250)

RuggedRouter  User Guide
SNMP V1 and V2 transmit information in clear text (which may or may not be an
issue depending the facilities the data is transmitted over) and are lacking in the
ability to authenticate a user. SNMP V3 adds strong authentication and encryption.
SNMP Configuration Main Menu
Figure 217: SNMP Main Configuration page
In order to enable snmpd (the snmp daemon) at each and every boot, use the System
folder, Bootup And Shutdown menu.
Note: Prior to ROX 1.10.0, SNMP was manually configured used the com2sec, group,
view and access directives. If so configured, the SNMP menu will prompt you to
convert the configuration to one it can manage.
System Configuration
Figure 218: System Configuration page
The System name, System location, System contact, and System description fields
configure descriptive parameters for the router.
Network Addressing Configuration
For reference, the set of currently configured and active IP addresses is listed near the
the top of the page.
Figure 219: Network Addressing Configuration page, Client Address
248 RuggedCom