Functions that can be assigned to a pedal – Roland V-Piano User Manual
Page 45
45
Playing
You can assign various functions to the piano pedals and to pedals connected to the PEDAL FC1 jack and PEDAL FC2 jack, and use
these pedals to control the V-Piano.
You can assign functions to the left piano pedal and the center piano pedal.
The right piano pedal and the pedal connected to the PEDAL DAMPER jack will always operate as damper pedals. You
cannot change these assignments.
Parameters for which a check mark appears in the “Together with another function” column allow two functions to be
simultaneously assigned to a single pedal.
SETUP UP and SETUP DOWN can be selected only if the pedal settings are the settings stored in system memory.
Using the pedals to control the V-Piano’s functions
Functions that can be assigned to a pedal
Function
Value
Together with
another function
Abbreviation in
the tone screen
Remarks
Operate as soft pedal
SOFT
✔
Soft
Operate as sostenuto pedal
SOSTENUTO
✔
Sosten
Turn on/off MIDI output of
performance data
MIDI OUT SW
M.Out
Play/stop the selected song
SONG PLAY/STOP
PlayST
Turn transpose on/off
TRANSPOSE SW
Trans
Linked with the [TRANSPOSE] button.
Move the playback position to the
beginning of the song
SONG RESET
Reset
Adjust the volume of the entire V-
Piano
MASTER VOLUME
✔
Volume
Linked with the utility screen’s “1.
System–Master Volume.”
The V-Piano’s volume
EXPRESSION
✔
Expres
Adjust the ambience
AMBIENCE LEVEL
✔
AmbLvl
Linked with the [AMBIENCE] Knob.
Adjust the tone parameter
SOUND LIFT
✔
S.Lift
STRING RESONANCE
✔
S.Reso
DAMPER RESONANCE
✔
D.Reso
SOUNDBOARD RESO
✔
Sndbd
The name of the tone parameter is
“Soundboard Resonance”
KEY OFF RESONANCE
✔
K.Reso
UNISON TUNE
✔
Tuning
HAMMER HARDNESS
✔
Hammer
CROSS RESONANCE
✔
C.Reso
DECAY TIME
✔
Decay
TONE COLOR
✔
TColor
DAMPING TIME
✔
D.Time
DAMPER NOISE LEVEL
✔
D.Nois
Recall the next setup
SETUP UP
SUP.Up
Recall the preceding setup
SETUP DOWN
SUP.Dn
V-Piano_e.book 45 ページ ２００９年１月２８日 水曜日 午前９時１０分