Roland V-Piano - Manual (Page 84)

84
Detailed settings for various functions (Utility screen)
fig.UtilPedal.eps
Here you can make settings for the piano pedals and for the pedals connected to the PEDAL FC1 jack / FC2 jack.
You cannot change the settings for the right piano pedal or the pedal connected to the DAMPER jack. These pedals will always
operate as damper pedals.
Pedal settings (4. Pedal)
Parameter Description Value Default Value
Piano Pedal Mode
Piano pedal settings can be saved within each setup (p. 59).
When you switch setups, this setting specifies whether the piano
pedal settings will change to the settings saved in that setup
(SETUP) or will not change (SYSTEM).
SETUP, SYSTEM SETUP
Center Pedal Assign
Specifies the function that will be controlled by the center piano
pedal.
Refer to “Functions that
can be assigned to a
pedal” (p. 85).
SOSTENUTO
Center Pedal Min Specifies the value sent when the center piano pedal is released.
(Range of values for the
assigned function)
(Minimum value for the
assigned function)
Center Pedal Max
Specifies the value sent when the center piano pedal is fully
depressed. (Maximum value for the
assigned function)
Left Pedal Assign
Specifies the function that will be controlled by the left piano
pedal.
Refer to “Functions that
can be assigned to a
pedal” (p. 85).
SOFT
Left Pedal Min Specifies the value sent when the left piano pedal is released.
(Range of values for the
assigned function)
(Minimum value for the
assigned function)
Left Pedal Max
Specifies the value sent when the left piano pedal is fully
depressed. (Maximum value for the
assigned function)
Foot Controllers Mode
Settings for the pedals connected to the FC1 jack and FC2 jack
are saved within each setup (p. 59). When you switch setups, this
setting specifies whether these pedal settings will change to the
settings saved in that setup (SETUP) or will not change (SYSTEM).
SETUP, SYSTEM SETUP
FC2 Assign
Specifies the function that will be controlled by the pedal
connected to the FC2 jack.
Refer to “Functions that
can be assigned to a
pedal” (p. 85).
SOSTENUTO
FC2 Min
Specifies the value sent when the pedal connected to the FC2
jack is released.
(Range of values for the
assigned function)
(Minimum value for the
assigned function)
FC2 Max
Specifies the value sent when the pedal connected to the FC2
jack is fully depressed. (Maximum value for the
assigned function)
FC1 Assign
Specifies the function that will be controlled by the pedal
connected to the FC1 jack.
Refer to “Functions that
can be assigned to a
pedal” (p. 85).
SOFT
FC1 Min
Specifies the value sent when the pedal connected to the FC1
jack is released.
(Range of values for the
assigned function)
(Minimum value for the
assigned function)
FC1 Max
Specifies the value sent when the pedal connected to the FC1
jack is fully depressed. (Maximum value for the
assigned function)
V-Piano_e.book 84 ページ ２００９年１月２８日 水曜日 午前９時１０分