3 displaying data pages – Raymarine autopilot + ST4000+ User Manual
Page 46
Chapter 3: Advanced Operation
31
3
3.3 Displaying data pages
Use the disp key to show ‘data pages’ of SeaTalk or NMEA data:
1. Press disp to access the first data page, and press it again to cycle
through each data page in turn:
•
to return to a previous data page, press disp for 1 second
within 2 seconds of displaying a page
•
when you cycle past the last data page, the display returns to
the current autopilot mode screen (for example, Auto)
2. Select the data page you want to use as the principle display on the
control unit:
•
the current autopilot mode is shown at the left of the display
and the autopilot bar graph remains in use
•
if you then select a new mode or make a course change, the
autopilot mode screen appears as a ‘pop-up’ for 5 seconds
Three data pages are set in the factory as a default (see diagram).
Within User setup you can select up to seven pages and control the
information they display (see page 104):
•
if the autopilot system cannot obtain the required information for
a data page, the display will show dashes instead of a value
•
the ‘direction-to-steer’ arrows relate to the data page information
•
most data pages show repeated data so you cannot adjust them:
the exceptions are the RESPONSE and RUDDER GAIN data pages
(if you have selected them for display) which you can adjust
using the -1 and +1 keys
D3314-2
Autopilot mode
Data page 1
Data page 3
Data page 2
Default data pages