Connecting to the control unit – Raymarine autopilot + ST4000+ User Manual
Page 94
Chapter 5: Installing the ST4000+
79
5
Note: If the wheel is bent or the wheel drive is off center, the pin will
move up and down in the back plate slot. As long as the pin does not
hit the top or bottom of the slot, this pin movement will not affect the
drive unit’s performance.
13. When you have checked alignment, fully tighten all four screws.
Connecting to the control unit
When you have attached the pedestal bracket, you need to connect the
wheel drive to the control unit. The drive unit is supplied with 4.5 m
(15 ft) of 2-core cable with a waterproof socket at one end.
1. Connect the socket to the plug on the wheel drive’s motor tube:
•
remove the socket cover
•
pull back the plug cover
•
align the locking ring, plug and socket as shown below
•
push the plug firmly into the socket
•
turn the locking ring 90° clockwise
•
make the connection waterproof by pulling the plug cover
across so it protects the plug and socket
Note: To remove the plug, pull back the cover and turn the locking
ring 90° anti-clockwise. If you disconnect the socket for any reason,
always use the attached rubber cover to protect the socket.
D5409-1
Cable
Plug cover
(pulled back)
Locking ring
Contact
Socket
Socket cover
Motor tube
Plug